SPUAT Cocky? Gilligan releases Bowl Plans

[WarTiger 3,916]

saw this on another board....had to share it for those that may not see it...

Toilet Cleaning Procedure for Cleaning for Health

Before you begin to clean a toilet, gather all needed materials including personal protection equipment such as gloves and eyewear. Using a disinfectant/detergent cleaner, mixed either in a spray bottle or in a bucket (according to label instructions), spray or wipe down all hard surfaces outside of the bowl ... paying close attention to high touch areas like the toilet seat and flush handle. In order to disinfect the surfaces, the surface must remain wet for ten minutes unless the label instructions state otherwise.

After the outside surfaces are wet, lower the waterline in the toilet bowl. This can be done in one of several ways.

1.) Taking your bowl swab, push the swab in and out of the trap quickly until water level drops into the trap.

2.) Using a bucket with approximately 1.5 gallons of water, pour into the toilet quickly.

3.) Turn the water to the toilet off and flush the toilet.

4.) Use a toilet plunger and force the water down and out of the trap.

After the water level has been dropped, spray the inside surfaces of the toilet bowl. Again, to totally disinfect the toilet, the surface must remain wet for ten minutes unless stated otherwise on the label. Using your bowl swab, begin swabbing under the rim and working down into the trap. After the appropriate time, flush the toilet and then go back and wipe down the outside surfaces including the toilet seat and handle.

Toilet Cleaning Procedure for Cleaning for Appearance

Before you begin to clean a toilet, gather all needed materials including personal protection equipment such as gloves and eyewear.

Using a disinfectant/detergent cleaner, mixed either in a spray bottle or in a bucket, spray down or wipe down all hard surfaces outside of the bowl paying close attention to high touch areas like the toilet seat and flush handle. In order to disinfect the surfaces, the surface must remain wet for ten minutes unless the label instructions state otherwise.

After the outside surfaces are wet, lower the waterline in the toilet bowl. This can be done in one of several ways (see instructions above).

After the water level has been dropped, apply the acid base bowl cleaner to your bowl swab. Take the bowl swab and begin swabbing under the rim working down. If there are tough stains on the bowl, a small amount of bowl cleaner may be applied to the stain. Extra bowl cleaner may also be applied to the swab and rested on top of the stain. Hard, stubborn stains can be removed with a pumice stick available from most janitor supply companies. Other tools A small mirror can be used to look under the rim to detect any stubborn stains that may also be contributing to malodors. A Black Light used in a dark restroom will also show urine salts and missed cleaning in and around toilets as well as urinals. Use the fluorescent type black light, not a screw-in bulb.

[Tiger in Spain 0]